TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 327 of 750

TM 5-5420-228-24

OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS

REPLACEMENT (Sheet 6 of 8)

10.

11.

12.

13.

14.

15.

16.

17.

18.

19.

20.

21.

relief valve (L) in vise.

Using 1-1/8 inch wrench, install

nipple (M) into relief valve (L).

Using 12 inch adjustable wrench, install

elbow (N) onto nipple (M).

Using care to prevent damage, clamp

Using 1-1/8 inch wrench, install nipple (P) into relief valve (L).

Holding nipple (P) with 1-1/8 inch wrench, use 1-3/8 inch wrench to install bushing (Q)

onto nipple (P).

NOTE

Install regulator (R) with flow arrow pointing away from relief valve (L).

Holding brushing (Q) with 1-3/8 inch wrench, use 15 inch adjustable wrench to install

regulator (R) onto bushing (Q).

Holding regulator (R) with 15 inch adjustable wrench, use 1-3/8 inch wrench to install

bushing (S) in regulator (R).

Holding bushing (S) with 1-3/8 inch wrench, use 12 inch adjustable wrench to install

elbow (T) into bushing (S).

Holding elbow (T) with 15 inch adjustable wrench, use 12 inch adjustable wrench to install

elbow (U) and collar (V) into elbow (T).

Remove relief valve (L) and attached parts from vise.

Using 12 inch adjustable wrench, install elbow (N) and attached parts in cap end of cylinder

(H).

Holding elbow (U) with 12 inch adjustable wrench, use 1-1/4 inch wrench to install hose

assembly (W) onto elbow (U).

Go on to Sheet 7

TA251528

3-130