TM-5-5420-228-24
LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
AUGUST 1985
TM-5-5420-228-24 - Page 318 of 750
TM 5-5420-228-24
PUMP RELIEF CHECK VALVE (CV5) REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
NOTE
Before installing, use pipe tape on all male threads. Start
tape on second thread so tape will not enter hydraulic
system.
1.
2.
3.
4.
5.
6.
7.
Holding elbow (A) with adjustable wrench,
using 1-1/2 inch wrench to install check
valve “CV5” (B) with flow arrow pointing
toward elbow (A).
Holding check valve “CV5” (B) with
1-1/2 inch wrench, use 1-1/8 inch wrench
to install bushing (C) with attached parts.
Holding elbow (D) with adjustable wrench, use 7/8 inch wrench to install hose assembly
“CV5” (E).
Service hydraulic reservoir (LO 5-5420-202-12).
Bleed hydraulic system (page 3-72).
Check for hydraulic leaks and correct as necessary.
Service hydraulic reservoir (LO 5-5420-202-12).
End of Task
TA251519
3-121
Back to Top
