TM-5-5420-228-24
LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
AUGUST 1985
TM-5-5420-228-24 - Page 516 of 750
TM 5-5420-228-24
HEU OR EARLY MODEL OVERHEAD CYLINDER REPAIR (Sheet 6 of 6)
18.
Service hydraulic reservoir (LO-12).
19.
Bleed hydraulic system (page 3-72).
20.
Extend overhead piston until rod end (Q) is
alined with mount (T) (TM-10).
21.
Using crowbar, lift overhead cylinder
and remove wooden block from beneath
overhead cylinder (C).
22.
Have one technician position rod end (Q)
in mount (T) while another inserts pin (R).
23.
Position two retainers (U), one on
each side of mount (T).
24.
Manually install 10 screws (V) and
lockwashers (W) securing retainers
(U) to mount (T).
25.
Using 1-5/16 inch socket, tighten 10 screws (V).
26.
Check for hydraulic leaks and correct as necessary.
27.
Service hydraulic reservoir (LO-12).
End of Task
Change 3
3-231
Back to Top
