TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 508 of 750

TM 5-5420-228-24

HEU OR EARLY MODEL OVERHEAD CYLINDER REPLACEMENT (Sheet 5 of 7)

WARNING

Make sure sling is wrapped on overhead cylinder (D) so that it cannot slide loose.

Personnel could be injured if cylinder comes loose during installation.

8.

Lift overhead cylinder (D) and position it between boom (E) and mount (F) with hydraulic openings facing up.

9.

Have two technicians p[osition overhead

cylinder (D) while third technician inserts

pin (G).

10.

Using snap ring pliers, install two retaining rings (H).

11.

Have two technicians position rod end

connector (B) while third inserts pin (C).

12.

Position two retainers (J) (one on each side).

13.

Install five screws (K) and lockwashers (L)

in each retainer (J).

14.

Using 1-5/16 inch

socket, tighten 10 screws (K).

15.

Using 7/16 inch socket, install four grease fittings (M).

16.

Remove sling and lifting device.

TA251621

Go on to Sheet 6

Change 3

3-229