TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 502 of 750

TM 5-5420-228-24

Section IV. HYDRAULIC CYLINDERS

OVERHEAD CYLINDER ARMOR REPLACEMENT (Sheet 1 of 2)

TOOLS:

9/16 in. socket with 1/2 in. drive

15/16 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

9/16 in. combination box end and open end wrench

Pry bar

Sling

Lifting device (200 lbs capacity)

SUPPLIES:

Lockwashers (6 required)

REFERENCE:

REMOVAL:

TM 5-5420-202-10

1.

Using 9/16 inch socket on screw (A) and box

wrench on nut (B), remove two screws (A), nuts

(B), lockwashers (C), four flat washers (D),

and stop (E). Throw lockwashers (C) away.

2.

Using 15/16 inch socket, remove four screws (F),

flat washers (G), and lockwashers (H).

Keep personnel clear and out from under

lifting device during lifting operation.

Failure to do so could result in personnel

being struck and seriously injured.

3.

Attach sling to forward end of armor (J) and

attach lifting device.

Using pry bar, raise rear end of armor (J) enough

4.

to get hooks of sling through fastener holes

at rear end of armor.

5.

Using lifting device, remove armor (J).

6.

Remove sling from armor (J).

TA251617

Go

on to Sheet 2

3-223