TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 505 of 750

TM 5-5420-228-24

HEU OR EARLY MODEL OVERHEAD CYLINDER REPLACEMENT (Sheet 2 of 7)

4.

Using adjustable wrench to hold adapter (G) and adapter elbow (H), use 1-1/4 inch wrench to remove assembly (F).

5.

Using adjustable wrench, remove elbow (A)

and its attached parts as an assembly.

6.

Using adjustable wrench, remove elbow (K)

and its attached parts as an assembly.

7.

Using 7/16 inch socket, remove four grease fittings (L).

NOTE

If necessary, use spreader when attaching sling and lifting device to overload

cylinder (M).

8.

Position sling around overhead cylinder (M) and attach lifting device.

WARNING

Make sure sling is wrapped on overhead cylinder (M) so that it cannot slide

loose. Personnel could be injured if cylinder comes loose during removal.

9.

Raise lifting device until sling is tight enough to support overhead cylinder (M).

TA251619

Go on to Sheet 3

3-226

Change 3