TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 503 of 750

TM 5-5420-228-24

OVERHEAD CYLINDER ARMOR REPLACEMENT (Sheet 2 of 2)

INSTALLATION:

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

Attach sling to armor (A).

Using lifting device, position armor (A) on overhead cylinder (B).

Remove sling from armor (A); use pry bar to

aid removal of hooks at rear of armor.

Place lockwashers (C) and flat washers (D) on four screws (E).

Using pry bar, aline holes of armor (A) with

those in overhead cylinder (B).

Manually install four screws (E),

Using 15/16 inch socket, tighten

lockwashers (C), and flat washers (D).

four screws (E).

Place flat washer (F) on two screws (G).

Position stop (H) on armor (A) and insert two screws (G).

Place flat washers (F), lockwashers (J), and nuts (K) on two screws (G).

Using 9/1 6 inch socket on screw (G) and wrench on nut (K), tighten two screws.

End of Task

3-224