TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 640 of 750

TM 5-5420-228-24

HYDRAULIC PUMP REPAIR (Sheet 10 of 11)

23.

24.

25.

26.

Supporting drive shaft (D) and attached

parts so parts do not separate, carefully

install bearing (AG), ring (AH), and bearing

housing (AJ).

Using arbor press, press new oil seal (AK)

into retainer (AL) with lip facing inside.

Supporting drive shaft (D) and attached parts,

install new gasket (AM) and retainer (AL).

Using 3/16 inch screw key, install four screws (AN).

30.

31.

32.

33.

27.

Have second technician lift bearing housing

(AJ) with attached parts and hold vertical.

NOTE

Install valve plate (AP) as noted

during disassembly.

28.

Place valve plate (AP) on cylinder block (Y).

29.

Place new

gasket (AQ) and new

preformed packing (AR) in position.

Place subdeck housing (AS) over assembled parts and onto bearing housing (AJ).

Aline screw holes and scribe marks on subdeck housing (AS)

Using 5/16 inch screw key, loosely install eight screws (AT).

Manually install alinement pin (AU) into valve plate (AP).

and bearing housing (AJ).

G

O

on to Sheet 11

TA251701

4-51