TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 639 of 750

TM 5-5420-228-24

HYDRAULIC PUMP REPAIR (Sheet 9 of 11)

NOTE

Cylinder bore (X) that is in line with cylinder

block (X)

y

retainer slots is No. 1 cylinder

bore. Piston (Z) that is in line with drive

shaft (0) retainer slots is No.

1 piston.

Remove protective caps as necessary.

16.

Insert No. 1 piston (Z) in No. 1 cylinder

bore (X).

17.

Insert two pistons (AA, AB) closest to

No. 1 position (Z) in their cylinder bores

(AC, AD).

18.

Continue inserting pistons, first on one

side of No. 1 piston, then on other side,

until only two pistons remain (AE, AF)

uninstalled.

19.

Tilt cylinder block (X) carefully back and

slip rear knuckle (V) into cylinder block

retainer with grooved end up.

20.

Tilt cylinder block (Y) forward and slide remaining knuckle (V) into remaining retainer

slot.

21.

Install two remaining pistons (AE,AF).

22.

Push cylinder block (Y) straight down to check installation.

Action should be smooth

and springy.

Go on to Sheet 10

4-50

TA251700