TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 629 of 750

TM 5-5420-228-24
CLUTCH ASSEMBLY
22.
23.
24.
25.
26.
27.
Using 1/4 inch
(N).
REPLACEMENT AND REPAIR (Sheet 8 of 9)
screw key, loosen setscrew
Place key (AE) in shaft (AF).
Insert shaft (AF) in clutch assembly (AG)
alining recess in shaft with setscrew (N)
and make sure shaft is seated in bearing.
Using 1/4 inch screw key, tighten set-
screw (N).
Gently pull shaft (AF) to make sure it
is firmly seated, being careful assembly
does not separate.
Manually install gear (AH) and bearing
(AJ) on clutch assembly (AG).
28.
Using arbor press, press ring (AK) on
sleeve (AL).
29.
Using 7/16 inch wrench, install lubrication
fitting (AM) on collar (AN).
30.
Place two halves of collar (AN) on sleeve
(AL).
31.
Manually install two bolts (AP), shims
(AQ), and nuts (AR).
32.
Holding two bolts (AP) with 9/16 inch
wrench, use 9/16 inch wrench to tighten
two nuts (AR).
Go on to Sheet 9
4-40
TA251691


Back to Top