TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 624 of 750

TM 5-5420-228-24
CLUTCH ASSEMBLY REPLACEMENT AND REPAIR (Sheet 3 of 9)
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
Manually remove bearing (C) and gear (D).
Using 1/4 inch screw key, loosen setscrew (E).
Manually pull out shaft (F).
Using pliers, remove key (G).
Holding two screws (H) with 9/16 inch
wrench, use 9/16 inch wrench to remove
two nuts (J).
Manually remove two screws (H) and
shims (K).
Separate two halves of collar (L) and
remove from sleeve (M).
Using 7/16 inch wrench, remove lubrication
fitting (N).
Using arbor press, remove sleeve (M)
from ring (P).
Remove locating pin from pin (A).
Using flat-tip screwdriver, remove three screws (Q) securing cover (B) to attached
parts.
G
O
on to Sheet 4
TA251686
4-35


Back to Top