TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 625 of 750

TM 5-5420-228-24
CLUTCH ASSEMBLY REPLACEMENT AND REPAIR (Sheet 4 of 9)
14.
15.
16.
17.
18.
19.
20.
Remove cover (B).
Remove pin (A) and spring (R).
NOTE
Do steps 16 and 17 only if identification plate
is defective.
Using hammer and chisel, tap out two drive scre
(S). Throw drive screws (S) away.
Remove plate (T) from cover (B).
Using pliers, remove three cotter pins (U). Thro
cotter pins (U) away.
Manually remove three pins (V) from yoke (W).
Separate six levers (X), three springs (Y),
and six pins (z).
Manually remove six springs (AA).
Manually remove three sets of friction linings
(AB), two clutch discs (AC), and hub and back-
plate (AD) from clutch spider assembly (AE).
Using 1/4 inch screw key, remove setscrew (E)
from hub and backplate (AD).
Using hammer and punch, remove six pins (AF).
Go On to Sheet 5
TA251687
4-36


Back to Top