TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 627 of 750

TM 5-5420-228-24
CLUTCH ASSEMBLY
3.
Inspect parts
REPLACEMENT AND REPAIR
for worn teeth, distortion,
Replace all worn or damaged parts.
ASSEMBLY:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Using 3/8 inch screw key, install setscrew (A).
(Sheet 6 of 9)
stripped threads,
and indications of wear.
Using 7/16 inch wrench, install lubrication fitting
Using arbor press, install bearing (C) into hub (D).
Place nameplate (E) in position on flange (F).
(B).
Using hammer, install two new drive screws (G).
Place flange (F) in position on hub (D).
Manually install eight screws (H) and nuts (J).
Using 9/16 inch wrench to hold screws (H), use 9/16 inch socket
to tighten nuts (J).
Using hammer, install six pins (K) in hub and backplate (L).
Manually install six springs (M) on pins (K).
Go on to Sheet 7
4-38
TA251689


Back to Top