TM 5-5420-228-24
CLUTCH ASSEMBLY REPLACEMENT AND REPAIR (Sheet 1 of 9)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
4-33
Disassembly
4-34
Cleaning and Inspection
4-37
Assembly
4-38
Installation
4-41
TOOLS: Flat-tip screwdriver
Chisel
7/16 in. open end wrench
Ratchet with 1/2 in. drive
Hammer
3/16 in. drive pin punch
9/16 in. socket with 1/2 in. drive
Long round nose pliers
9/1 6 in. open end wrench (2)
1/4 in. socket head screw key
3/8 in. socket head screw key
Bearing puller
Arbor press
SUPPLIES:
Dry cleaning solvent (It em 15, Appendix D)
Gloves (Item 27, Appendix D)
Rags (Item 12, Appendix D)
Goggles (Item 26, Appendix D)
Compressed air source
Shield (Item 33, Appendix D)
1/16 in. locating pin
Paper (Item 23, Appendix D)
Grease (Item 9, Appendix D)
Drive screws (4 required)
Cotter pins (3 required)
Drive screws (4 required)
PRELIMINARY PROCEDURES:
Remove pump-clutch drive (page 4-23)
REMOVAL:
1.
Push down o
is disengage
n hand lever (A) to make sure clutch.
Go on to Sheet 2
TA251684
4-33