TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 613 of 750

TM 5-5420-228-24

PUMP-CLUTCH DRIVE REPLACEMENT (Sheet 2 of 4)

4.

5.

6.

7.

drive (F) to rear out of clutch (A).

8.

Slide pump-clutch

Remove key (E).

NOTE

Be careful to not lose key (E) When removing

pump-clutch drive (F) from clutch.

Take pump-clutch drive to shop area.

Using snap ring pliers, remove two retaining rings (G).

Using arbor press on long end of shaft (H),

press shaft (H) and bearing (J) out of housing

(K).

9.

Using arbor press, remove bearing (J) from shaft (H).

10.

Using puller, remove bearing (L) from housing (K).

CLEANING AND INSPECTION:

WARNING

Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away

from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,

mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.

1.

Clean all metallic parts with rags and

dry cleaning solvent.

Go on to Sheet 3

TA251675

4-24