TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 621 of 750

TM 5-5420-228-24
PUMP-CLUTCH SUPPORT REPLACEMENT (Sheet 1
TOOLS: 9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
1/4 in. drive pin punch
3/4 in. socket with 1/2 in. drive
10 in. extension with 1/2 in. drive
Hammer
SUPPLIES:
Lockwashers (8 required)
Lockwashers (4 required)
PRELIMINARY PROCEDURES:
REMOVAL:
1.
2.
3.
4.
5.
Using 9/16 inch socket, remove
screws (A) and lockwashers (B).
Throw lockwashers (B) away.
Using punch
and hammer,
spacer (C).
Remove
Remove
four
tap out
Using 9/16 inch socket and extension)
remove eight screws (D) and lock-
washers (E). Throw lockwashers (E) away.
Using 3/4 inch socket, remove two
screws (F).
Remove pump-clutch support (G).
INSTALLATION:
1.
2.
3.
4.
5.
6.
7.
Place pump-clutch support (G) in position in
Of 1)
pump (page 4-29)
clutch controls (page 4-27)
vehicle.
Using 3/4 inch socket, install two screws (F).
Using 9/16 inch socket, install eight screws (D) and lockwashers (E).
Using hammer and punch, tap spacer (C) into place.
Using 9/16 inch socket, install four screws (A) and lockwashers (B).
Install pump (page 4-30).
h-stall clutch controls (page 4-28).
End of Task
4-32
TA251683


Back to Top