TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 631 of 750

TM 5-5420-228-24
HYDRAULIC PUMP REPAIR (Sheet l of 11)
PROCEDURE INDEX
PROCEDURE
PAG E
Disassembly
4-42
Cleaning and Inspection
4-47
Assembly
4-48
TOOLS: Long round nose pliers
3/16 in. socket head screw key
5/16 in. socket head screw key
9/16 in. socket head screw key
Arbor press
1/4 in. drive pin punch
Hammer
3/4 in. open end wrench
Scriber
Puller kit
Spray gun with air filter and water separator
Gun, air blow
Flat- tip screwdriver
SUPPLIES:
Dry cleaning solvent (Item 15, Appendix D)
Gasket
Cotter pin
Rags (Item 12, Appendix D)
Lapping compound (Item 6, Appendix D)
Compressed air source
Paper (Item 23, Appendix D)
Gloves (Item 27, Appendix D)
Goggles (Item 26, Appendix D)
PERSONNEL:
Two
Preformed packing
Protective caps and plugs
(assorted sizes)
Hydraulic fluid (Item 8,
Appendix D)
Gasket kit
Crocus cloth (Item 5,
Appendix D)
Oil seal
Shield (Item 33, Appendix D)
PRELIMINARY PROCEDURE: Remove hydraulic pump (page 4-29)
Go on to Sheet 2
4-42


Back to Top