TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 637 of 750

TM 5-5420-228-24
HYDRAULIC PUMP REPAIR (Sheet 7 of 11)
5. Valve plate (F) and cylinder block (C)
must mate perfectly.
Check mating
surfaces for flat fit. If either surface
is gouged, nicked, or damaged, replace
6.
part.
Examine all other parts for scratches, nicks, burrs,
distortion, elongated holes, stripped
threads, and firmness of fit. Replace defective parts.
ASSEMBLY:
NOTE
Install bearings (A,B,C) on drive shaft (D) in
order and position shown.
1. Manually place washer (E), bearing (A), and
spacer (F) on drive shaft (D).
2.
3.
4.
Using arbor press, install bearing(A) .
Manually place bearings (B) and (C) and spacer (G) on drive shaft (D) .
Using arbor press, install bearings (B) and (C).
Go on to Sheet 8
4-48
TA251698


Back to Top