TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 656 of 750

VALVE BANK ASSEMBLY AND BRACKETS REPLACEMENT
52.
53.
54.
55.
56.
57.
58.
59.
Using 5/8 inch wrench to hold four
screws (BU), use 3/4 inch wrench
to loosen four nuts (BV).
Manually remove four screws (BU),
.
(Sheet 9 of 17)
TM 5-5420-228-24
nuts (BV), flat washers (BW), and
lockwashers (BX). Throw lock-
washers (BX) away.
Remove two brackets (BY) from
valve bank (Z).
Using 1-3/8 inch wrench, remove
adapter (BZ) and attached parts
from elbow (CA).
Holding adapter (CB) with 1-3/8
inch wrench, use adjustable wrench
to remove elbow (CA).
Holding adapter (CC) with 1-1/4 inch wrench, use adjustable wrench to remove tee (CD)
and attached parts from adapter (CC).
Using 1-3/8 inch wrench, remove adapter (CE) and attached parts from valve bank (Z).
Using 3/8 inch screw key, remove pipe plug (CF).
CLEANING AND INSPECTION:
WARNING
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away
from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,
mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.
1.
Using dry cleaning solvent, clean all parts.
2.
Using rags, dry all parts.
3.
Inspect all parts for breaks, cracks, and
excessive wear.
Replace bad parts.
Go on to Sheet 10
TA251710
4-61


Back to Top