TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 660 of 750

TM 5-5420-228-24
VALVE BANK ASSEMBLY AND BRACKETS REPLACEMENT (Sheet 13 of 17)
36.
37.
38.
39.
40.
41.
42.
43.
44.
Manually position identification
plates (AT) on valve bank (B).
Manually position two brackets (AU)
on valve bank (B) (one on each end).
Manually install four screws (AV),
lockwashers (AW), and nuts (AX).
Using 3/4 inch wrench to hold nuts
(AX), use 3/4 inch socket to tighten
screws (AV).
Manually install two screws (AY), lockwashers (AZ), and nuts (BA).
Using 1/2 inch wrench to hold screw (AY), use 1/2 inch socket to tighten nut (BA).
Manually install two screws (BB), lockwashers (BC), and nuts (BD).
Using 7/16 inch wrench to hold screws (BB), use 7/16 inch socket to tighten nuts (BD).
Using second technician, position valve bank assembly (B) and brackets (AU) in vehicle.
Go on to Sheet 14
TA251714
4-65


Back to Top