TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 657 of 750

TM 5-5420-228-24

VALVE BANK ASSEMBLY AND BRACKETS REPLACEMENT (Sheet 10 of 17)

INSTALLATION:

NOTE

Remove caps and plugs as necessary during

installation.

Before installation use pipe

tape on all male threads. Start pipe tape

on second thread so that tape will not enter

hydraulic system.

1.

2.

3.

4.

5.

6.

7.

8.

Using 3/8 inch screw key, install

pipe plug (A) into valve bank (B).

Using 1/4 inch screw key, install

pipe plug (C) into valve bank (B).

Using 1-3/8 inch wrench, install

adapter (D) and attached parts

into valve bank (B).

Using adjustable wrench, install

tee (E) and attached parts on

adapter (F).

Using adjustable wrench, install

elbow (G).

Using 1-3/8 inch wrench, install adapter (H) and attached parts on elbow (G).

Position two brackets (J) on valve bank (B), one on each end.

Using 5/8 inch wrench on four screws (K), use 3/4 inch wrench to install

lockwashers (L), flat washers (M), and nuts (N).

Go on to Sheet 11

4-62

TA251711