TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 667 of 750

TM 5-5420-228-24
HEU VALVE BANK ASSEMBLY CONTROLS REPLACEMENT (Sheet 1 of 2)
PROCEDURE INDEX
P
r
o
c
e
d
u
r
e
s
P
a
g
e
Removal
4-72
Installation
4-73
TOOLS:
Long round nose pliers
9/16 in. combination box and open end wrench
Hammer
SUPPLIES:
Lockwasher (3 required)
REFERENCE: TM-10
PRELIMINARY PROCEDURES:
None
REMOVAL:
1.
Using long round nose pliers, remove two C-clips (A) and two washers (B).
2.
Using long round nose pliers, remove ten C-clips (C).
3.
Remove ten straight pins (D) and links (E).
4.
Using long round nose pliers, slowly pull out rod (F).
5.
Remove five control levers (G).
6.
Manually remove five knobs (H) by unscrewing from control levers (G).
7.
Using 9/16 inch wrench, remove three screws (J) and three lockwashers (K).
Remove control bracket (L).
Go on to Sheet 2
4-72
Change 3


Back to Top