TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 676 of 750

TM5-5420-228-24

RESERVOIR QUADRANT REPLACEMENT (Sheet 3 of 4)

CLEANING:

1.

Using putty knife, remove sealing compound from

and vehicle.

mating surfaces of reservoir quadrant

WARNING

Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away

from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,

mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.

2.

Clean using rags and dry cleaning solvent.

INSTALLATION:

NOTE

Before installing, use pipe tape on all male

threads. Start tape on second thread so

tape will not enter hydraulic system.

1.

2.

3.

4.

5.

6.

7.

Using putty knife, apply sealant to mating surfaces

of vehicle and reservoir quadrant (A).

Attach sling and lifting device to two handles (B).

Have technician operating hoist slowly lift quadrant (A)

into position over vehicle.

While two technicians guide reservoir

quadrant (A), have technician operating

hoist slowly lower reservoir quadrant (A)

into position on vehicle.

Remove lifting device and sling from two

handles (B).

Using 3/4 inch socket, install seven

screws (C) and lockwashers (D).

Using 1-5/16 inch socket, install four

screws (E) and lockwashers (F).

Go on to Sheet 4

4-94

TA251742