TM-9-1200-215-34-P
AUTOMATIC FIRE CONTROL SYSTEM (AFCS)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
FEBRUARY 1999
TM-9-1200-215-34-P - Page 11 of 266
TM
9–1200–215–34&P
iv
HOW
T
O USE THIS MANUAL
Indexing
Five major indexing procedures are used in this manual to help the technician locate information rapidly.
1.
Cover index:
Lists sections of text and page number.
2.
Table of Contents: Pages i through iii.
3.
Chapter indexes:
Lists information covered within the chapter and section.
4.
Location and description of major components.
5.
Index, pages INDEX–1 through INDEX–6:
Alphabetical listing of information.
Maintenance Text and Illustrations (Chapter 2 through 6)
1.
Maintenance procedures are to be performed in the sequence shown in the text and illustrations.
Step 1 must be performed before Step 2. Procedure
a
must be performed before Procedure
b
, and
so on.
2.
Equipment illustrations use numbers to identify parts of the system/components.
Example:
1.
Remove both wiring harnesses (1) and (2).
2.
Remove four screws (3), four flat washers (4), four lockwashers (5), and four nuts (6).
REPAIR PARTS LIST
Repair Parts List is contained in Appendix C of this manual.
How to locate parts:
D
Identify the item on the applicable figure and note the item number.
Refer to the applicable parts list and
use the item number as the locator.
D
Determine part number of the item from the parts list.
A cross reference of part numbers and figure num-
bers is located after the last figure in Appendix C.
Back to Top
