TM-9-2320-209-10-4
2 1/2-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; OPERATOR LEVEL
SEPTEMBER 1980
TM-9-2320-209-10-4 - Page 54 of 87
TM 9-2320-209-10-4
b .
Replacement.
1.
2.
3.
4.
WARNING
Never use rivets, bolts, steel pins, or any other type metal
pin in place of shear pin (1).
Make sure you use the correct
part number aluminum shear pin only. Damage to the equip-
ment and injury to personnel can happen if wrong shear pin
is used.
Spread a small amount of grease around new shear pin (1).
Turn drive sprocket (2) until shear pin (1) holes line up. Put in shear pin.
Using drift punch and hammer, tap in sheer pin (1) until cotter pin holes on each
end of pin can be seen.
Using pliers, put in cotter pin (3) in each end of shear pin (1). Bend back ends
of cotter pins.
END OF TASK
2-42
Back to Top
