TM-9-2320-209-10-4
2 1/2-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; OPERATOR LEVEL
SEPTEMBER 1980
TM-9-2320-209-10-4 - Page 47 of 87
TM 9-2320-209-10-4
Section V. WINCH EQUIPMENT ITEMS MAINTENANCE
2-10. FRONT WINCH SHEAR PIN REMOVAL AND REPLACEMENT.
TOOLS:
l/4-inch drift punch
Ballpeen hammer, light
Pliers
SUPPLIES:
Artillery and automotive grease, type GAA, MIL-G-10924
Cotter pin (2)
PERSONNEL: One
EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.
a.
Removal.
FRAME 1
1.
Working under front left side of truck, find universal joint (1).
2.
Turn universal joint (1) on winch drive shaft (2) until shear pin (3) can be
seen.
3.
Using pliers, take out two cotter pins (4), one on each end of shear pin (3).
GO TO FRAME 2
2-35
Back to Top
