TM 9-2320-209-20-3-1
c. Replacement.
WARNING
Dry cleaning solvent is flammable. D
O
not use near open
flame.
Keep a fire extinguisher nearby when working
with solvent.
to do this will
to equipment.
Use only
result in
in well-ventilated area.
Failure
injury to personnel and damage
NOTE
Before installing water pump, clean pump using solvent.
Make sure that all surfaces contacting gaskets or hose
are smooth and free of dirt.
1.
Place water pump (1) on front of engine block as shown.
2.
Put three bolts with lockwashers (2) through water pump mounting holes and
using 9/16–inch wrench, tighten bolts.
3.
Put hose (3) on water pump ( 1). Slide clamp (4) into place. Using screw-
driver, tighten clamp.
4.
Slide hose (5) down from thermostat housing (6) over water pump (1) outlet
as shown.
5.
Put clamps (7) near ends of hose (5) as shown. Using screwdriver, tighten
two screws (8).
GO TO FRAME 2
TA 047015
6-40