TM-9-2320-209-20-3-2
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4
MAY 1981
TM-9-2320-209-20-3-2 - Page 100 of 552
TM 9-2320-209-20-3- 2
13-13 .
HYDRAULIC LINES, HOSES, AND FITTINGS REMOVAL AND REPLACEMENT .
NOT E
Procedures given are typical and cover all th e
different types of installations that you will fin d
on the trucks .
Refer to system schematic illustra -
tions used as support diagrams for troubleshootin g
each system (vol. 2, chapter 12, Fig. 46-1).
TOOLS :
6-inch plier s
Cross-tip screwdriver (Phillips type )
Cutting plier s
15/16-inch
open
end
wrench
9/16-inch
open
end
wrench
5/8-inch wrenc h
7/16-inch open end wrenc h
3/4-inch open end wrenc h
1-gallon containe r
7/8-inch open end wrenc h
7/16-inch combination bo x
1/2-inch open end wrenc h
and open end box wrenc h
13/16-inch
combination
box
5/8-inch combination bo x
open end box wrenc h
and open end box wrenc h
SUPPLIES :
Cap s
Tag s
Plastic tie s
PERSONNEL: On e
an d
EQUIPMENT CONDITION :
Truck parked, engine off, handbrake set .
13-8 7
Back to Top
