TM 9-2320-209-20-3-2
Section IV. TORQUE RODS
17-12. TORQUE RODS REMOVAL AND REPLACEMENT.
TOOLS:
1 7/16-inch deep socket wrench
Socket handle
2 x 30-inches round steel stock 10-pound sledge hammer
6-inch diagonal cutting pliers 7/16-inch wrench (2)
1 7/16-inch crow foot adapter Flat-tip screwdriver
Torque wrench, 600 pound-feet
capacity
SUPPLIES:
None
PERSONNEL: Two
EQUIPMENT CONDITION:
Truck parked, engine off, handbrake set, front
wheels chocked.
a.
Preliminary Procedures.
(1) Jack up and support rear axle housings. Refer to Part 1, para 11-3.
(2) Remove all rear wheels. Refer to TM 9-2320-209-10.
(3) Take off left side spring saddle to remove upper torque rods on left
side of truck. Refer to para 17-8.
17-61