TM-9-2320-209-20-3-4
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4
MAY 1981
TM-9-2320-209-20-3-4 - Page 35 of 410
TM 9-2320-209-20-3-4
FRAME 3
Soldier A
Soldier B
Soldier A
Soldier B
Soldier A
Soldier B
Soldiers
A and B
1.
2.
3.
4.
5.
6.
7.
Turn locking latch (1) to lock position. Move and hold rear winch
control lever (2) forward against edge of locking latch.
Hold up control rod (3) and clevis (4) to check alinement of holes
in clevis and pivot arm (5). Check how far clevis must be moved
in or out for pin (6) to fit freely through holes.
Turn locking latch (1) to unlock position. Move winch control
lever (2) to the rear.
Using adjustable wrench, turn clevis (4) in or out as needed to
aline holes for pin (6).
Slowly move winch control lever (2) forward until soldier B tells
you to stop.
When holes in clevis (4) and pivot arm (5) aline, tell soldier A to
stop.
Put in pin (6) and check for free fit. If pin fits freely, go
to frame 4.
If pin (6) does not fit freely, do steps 3, 4, 5, and 6 again.
GO TO FRAME 4
TA 08090 2
19-22
Back to Top
