TM-9-2320-209-20-3-4
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4
MAY 1981
TM-9-2320-209-20-3-4 - Page 29 of 410
TM 9-2320-209-20-3-4
19-5. FRONT WINCH PROPELLER SHAFT REMOVAL AND REPLACEMENT.
TOOLS:
Pliers
8-ounce ballpeen hammer
1/4-inch punch
9/16-inch wrench (2)
SUPPLIES:
None
PERSONNEL: One
EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.
a.
Removal.
1.
2.
GO
Working under front of truck and using pliers, pull out one of two cotter pins
(1) from shear pin (2) in front universal joint yoke (3).
Using hammer and punch,
drive shear pin (2) out of universal joint yoke (3).
Leave other cotter pin (1) in shear pin.
TO FRAME 2
TA 08086 8
19-16
Back to Top
