TM-9-2320-209-20-3-4
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4
MAY 1981
TM-9-2320-209-20-3-4 - Page 27 of 410
TM 9-2320-209-20-3-4
19-4. FRONT WINCH REMOVAL
AND REPLACEMENT.
TOOLS:
3/4-inch wrench
Chain sling
Hoist
SUPPLIES: Wood blocks
PERSONNEL: Two
EQUIPMENT CONDITION:
Truck parked, engine off, handbrake set.
a.
b.
Preliminary Procedures.
(1) Remove front winch propeller shaft. Refer to para 19-5.
(2) Remove front winch cable. Refer to para 19-10.
Removal.
FRAME 1
1. Put chain sling (1) around drum of winch (2) and join chain sling
to hoist.
2. Raise hoist enough to hold weight of winch (2).
3. Using 3/4-inch wrench, unscrew and take out six screws (3),
lockwashers (4), and flat washers (5).
4. Do step 3 again on other side of winch (2).
Soldier A 5. Guide winch (2) while soldier B lifts it off truck.
Soldier B 6. Using hoist, lift winch (2) off truck and set it down on wood
blocks.
Soldier A 7. Unhook chain sling (1) from hoist and take it off drum of winch
(2).
END OF TASK
TA 08086 6
19-14
Back to Top
