TM-9-2320-209-20-3-4
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4
MAY 1981
TM-9-2320-209-20-3-4 - Page 85 of 410
TM 9-2320-209-20-3-4
FRAME 3
1.
Using 6-inch ruler, measure slack in drive chain (1) at midpoint between two
sprockets (2 and 3). If slack is 1/2 inch, adjustment is correct.
2.
If there is too much slack in drive chain (1), using prybar (4) as shown, push
winch assembly (5) to the left. If there is not enough slack in drive chain,
using prybar (6) as shown, push winch assembly (5) to the right.
3.
After adjusting winch assembly (5), do step 1 again to check adjustment.
GO TO FRAME 4
19-72
Back to Top
