TM-9-2320-209-20-3-4
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4
MAY 1981
TM-9-2320-209-20-3-4 - Page 83 of 410
TM 9-2320-209-20-3-4
19-14.
REAR WINCH DRIVE CHAIN ADJUSTMENT (TRUCK M756A2).
TOOLS:
1/2-inch wrench (2) 15/16-inch wrench
15/16-inch socket Breaker bar
6-inch ruler Prybar
Drill
6-inch extension
SUPPLIES: None
PERSONNEL: One
EQUIPMENT Condition: Truck parked, engine off, handbrake set.
a. Preliminary Procedure. Pull both gin poles away from truck. Refer to TM
9-230-209-10.
b. Adjustment.
FRAME 1
1.
Using 1/2-inch wrenches, unscrew and take out four screws (1) and nuts (2).
2.
Take off floor plate (3).
3.
Using 15/16-inch wrench, breaker bar, and 15/16-inch socket, loosen six
screws (4) and nuts (5).
GO TO FRAME 2
19-70
Back to Top
