TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

  TM-9-2320-209-34-2-3 - Page 110 of 592

TM 9-2320-209-34-2-3
d.
Cleaning. There are no special cleaning procedures required. Refer
to
cleaning procedures given in Part 1, para 1-3.
e.
Inspection and Repair.
FRAME 1
1.
2.
3.
4.
GO
Check that idler pulley shaft (1) is not nicked, cracked, galled, scored or has
no damaged threads.
If idler pulley shaft (1) is damaged, get a new one.
Put clean lubricating oil ICE, OE/HDO 10, MIL-L-2104 on two bearings (2)
and turn by hand.
The bearing must turn without binding. If bearing
assemblies are damaged, put in new ones.
Check that two bearing cups (3) are not scored or pitted. If bearing cups are
damaged, get new ones.
Check that bearing seals (4 and 5) are not worn, torn or burned. Be sure
seal makes good seal contact with pulley (6). If bearing seals are damaged,
get new ones.
TO FRAME 2
18-99


Back to Top