TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 379 of 592

TM 9-2320-209-34-2-3

FRAME 7

NOTE

Put gasket (1), orifice plate

plate (4) exactly as shown.

assembly (5) on fuel control

1.

Put new gasket (1), orifice plate (2),

2.

Put orifice plate and gasket assembly

(2), and gasket (3) on cover

Put orifice plate and gasket

valve (6) exactly as shown.

and new gasket (3) on cover plate (4).

(5) on fuel control valve body (6).

3.

Put thermostat (7) and clamp (8) on orifice plate and gasket assembly (5).

4.

Screw in three screws (9) finger tight. Tighten three screws evenly,

tightening each one a little at a time.

5.

Slide two electrical leads (10) on terminals of thermostat (7).

6.

Do frame 2 again if fuel control valve did not pass fuel flow test. If fuel

control valve still does not pass fuel flow test, get new fuel control valve.

END OF TASK

21-44