TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 373 of 592

TM 9-2320-209-34-2-3

(5) Fuel control valve.

FRAME 1

WARNING

Dry cleaning solvent is flammable. Do not use near an

open flame. Keep a fire extinguisher nearby when sol-

vent is used. Use only in well-ventilated places. Fail-

ure to do this may result in injury to personnel and

damage to equipment.

CAUTION

Do not dip fuel control valve (1) in dry cleaning solvent.

Electrical parts may be damaged by doing so.

1.

Wipe fuel control valve (1) clean with a clean cloth dipped in dry cleaning

solvent.

Wipe fuel control valve (1) dry.

2.

Inspect fuel control valve (1) for cracked or broken parts. Go to step 6 if

cracks or breaks are found.

3.

Inspect electrical leads (2, 3, 4, 5, 6, and 7) for broken or frayed insulation

or damaged connectors on the ends.

Go to step 6 if any electrical leads or

connectors are bad.

4.

Using an ohmmeter, check continuity through heater. Place

on terminal (8) and the other ohmmeter lead on terminal (9).

be closed. If circuit is open, go to step 6.

5.

If fuel control valve (1) passes tests, to go frame 2. If you

fuel control valve, do step 6.

NOTE

Electrical leads (2 and 7) must be used on new fuel

trol valve.

one ohmmeter lead

Circuit should

must get a new

con-

6.

Unscrew and take off nut (10). Take off electrical lead (2) and slide off

electrical lead (7).

Get a new fuel control valve.

GO TO FRAME 2

21-38