TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 365 of 592

TM 9-2320-209-34-2-3

(1) Burner and heat exchanger.

FRAME 1

1. Take off gasket (1) from igniter (2). Throw away gasket (1). Make a note

whether the amount of carbon on the igniter (2) is a light coating or heavy

build-up. Throw igniter away.

2.

Take off gasket (3) and preformed packing

away gasket and preformed packing. Make

burner (5). Do not take burner apart any

CAUTION

(4) from burner (5). Throw

a note of amount of carbon on

further.

Do not damage screen or wick when scraping carbon.

If they are damaged, get new burner assembly (5).

3.

Scrape carbon from burner assembly (5) using a sharp tool.

4.

Inspect heat exchanger (6) for dents or possible leaks. Get new heat

exchanger (6) if it is dented or leaking.

WARNING

Eye shields must be worn when using compressed

air.

Eye injury can occur if eye shields are not

used.

5. Soak heat exchanger (6) in water for a few minutes. Blow out with compressed

air.

END OF TASK

21-30