TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

  TM-9-2320-209-34-2-3 - Page 81 of 592

TM 9-2320-209-34-2-3
18-5. REAR WINCH REMOVAL, REPAIR, AND REPLACEMENT (TRUCK M764).
TOOLS:
No special tools required
SUPPLIES: Lubricating grease, type GAA, MIL-G-10924
Lubricating oil, ICE, OE/HDO 10, MIL-L-2104
Lubricating oil, GO 80/90, Universal
Honing stone
Crocus cloth, type J
Artus shim stock or equivalent
Felt washer, pn 11623070 (2)
Gasket, pn 7701753 (2)
Gasket, pn 7701749 (3)
Seal, pn 500156
Seal, pn 11621388
Shear pin, pn 11609886 (3)
Link assembly, pn 11623139-2 (2)
Spring clip, pn 11609932-2 (2)
Rivet, pn MS20613-8P28
Taper pin, pn MS24692-331
PERSONNEL:
Two
EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.
a. Preliminary Procedures.
(1)
Remove cab protector. Refer to TM 9-2320-209-20.
(2) Remove power divider. Refer to para 18-12.
(3)
Remove winch drive chain. Refer to para 18-6.
(4)
Remove reduction drive chains. Refer to TM 9-2320-209-20.
(5)
Remove winch cable. Refer to TM 9-2320-209-20.
(6)
Remove carriage cross chains. Refer to TM 9-2320-209-20.
18-70


Back to Top