TM-9-2320-260-10
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 1985
TM-9-2320-260-10 - Page 103 of 411
2-58
Change 4
TM 9-2320-260-10
Table 2-2. Preventive Maintenance Checks and Services (Cont’d).
ITEM
NO.
INTERVAL
ITEM TO
CHECK/
SERVICE
CREWMEMBER
PROCEDURE
NOT FULLY
MISSION
CAPABLE IF:
LOCATION
DRIVER
26
During
Engine
Coolant
Heater
a.
Check for exhaust leakage while
a.
Any exhaust
operating heaters.
leakage.
b.
Listen for unusual heater noises
b.
Unusual noise
during operation.
is evident.
DRIVER
27
During
Wrecker
Rear Winch
a.
While operating wrecker rear
a.
Cable frayed,
winch, inspect cable for kinks, breaks,
kinked, or broken.
and frayed wire.
b.
While operating rear winch, check
b.
Controls are
all controls for proper operation. They
inoperative.
are: cable tensioner valve (1), throttle
control lever (2), winch shift control (5),
clutch control lever (4), and shift lever
lockpin (3).
c.
Inspect hose assemblies for leaks.
c.
Any class III
leak is evident.
DRIVER
28
During
Van
Operate hydraulic liftgate (6) through
No control
Hydraulic
full range of movement. Use electric
response. Any
Liftgate
switch (9) inside van, and PTO
class III leak is
controls (7) and (8), on rear of van.
evident.
WARNING
Do not operate heater if exhaust
leakage is noted. Exhaust gases can
kill.
2
3
4
1
5
WARNING
Wear hand protection when handling
winch cable. Do not handle cable
with bare hands. Broken wires will
cause injury.
Back to Top
