TM-9-2320-260-10
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 1985
TM-9-2320-260-10 - Page 96 of 411
Change 4
2-51
TM 9-2320-260-10
Table 2-2. Preventive Maintenance Checks and Services (Cont’d).
ITEM
NO.
INTERVAL
ITEM TO
CHECK/
SERVICE
CREWMEMBER
PROCEDURE
NOT FULLY
MISSION
CAPABLE IF:
LOCATION
EXTERIOR OFVEHICLE
DRIVER
16
Before
Van
a.
Before operating liftgate (7),
a.
Any class III
Hydraulic
inspect hydraulic hoses for leaks,
leak is evident.
Liftgate
abrasions, and fittings.
b.
Check hydraulic oil level by
b.
Any class III
removing filler cap (8) and pulling out
leak is evident.
dipstick (9). Oil level should be at the
third mark from top of gauge, with lift-
gate up in traveling position. If oil level
is low, fill to top line (LO 9-2320-260-12).
After check, ensure filter cap (8) is tight.
CAUTION
Before opening reservoir, ensure
area around reservoir filler cap is
clean. Do not allow dirt, dust, or
water to enter reservoir. Failure to
do this will cause damage to internal
components.
7
9
8
Back to Top
