TM-9-2320-260-20

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

APRIL 1995

TM-9-2320-260-20 - Page 1023 of 1337

TM 9-2320-260-20

I

13-21. WRECKER REAR WINCH CABLE ROLLER REPLACEMENT

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

M816

TM 9-2320-260-10

MATERIALS/PARTS

Four lockwashers

TM 9-2320-260-20P

EQUIPMENT CONDITION

Parking brake set (TM 9-2320-260-10).

NOTE

All rear winch cable rollers are replaced basically the same. There

are two rollers alined vertically, and two alined horizontally. This

procedure is for vertically alined rollers.

1. Remove two screws (8), lockwashers (7), and plate (6) from bracket (5). Discard lockwashers (7).

2. Remove shaft (10) from roller (14).

3. Remove two lubrication fittings (9) from shaft (10).

4. Remove two screws (4), lockwashers (3), and plate (2) from bracket (5). Discard lockwashers (3).

5. Remove roller (14) from bracket (5).

6. Remove retainer (1), spacer (17), washer (16), bearings (15) and (13), washer (12), and spacer (11)

from roller (14).

1. Install bearings (13) and (15), washer (12), spacer (11), washer (16), spacer (17), and retainer (1)

on roller (14).

2. Position roller (14) on bracket (5).

3. Install plate (2) on bracket (5) with two new lockwashers (3) and screws (4).

4. Install two lubrication fittings (9) on shaft (10).

5. Position shaft (10) through roller (14) and install on bracket (5) with plate (6), two new

lockwashers (7), and screws (8).

13-50