TM-9-2320-260-20

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

APRIL 1995

TM-9-2320-260-20 - Page 1101 of 1337

TM 9-2320-260-20

I

13-57. POWER DIVIDER-TO-REAR WINCH DRIVE PROPELLER SHAFT REPLACEMENT

I

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

M816

TM 9-2320-260-10

MATERIALS/PARTS

Four lockwashers

TM 9-2320-260-20P

EQUIPMENT CONDITION

●

Parking brake set (TM 9-2320-260-10).

●

Drivechain and sprocket removed (para. 13-17).

1. Remove two nuts (7), screws (1), four lockwashers (2), and plate (4) from roller bracket (3). Discard

lockwashers (2).

2. Remove shaft (5) and roller (6) from roller bracket (3).

3. Remove rear winch propeller shaft (8) from yoke (10)

4. Guide propeller shaft (8) through rear crossmember

and center bearing (9).

11).

1. Guide propeller shaft (8) through rear crossmember (11).

2. Install rear winch propeller shaft (8) in center bearing (9) and yoke (10).

3. Install roller (6) and shaft (5) on roller bracket (3) with plate (4), four new lockwashers (2), two

screws (1), and nuts (7). Tighten nuts (7) 70-98 lb-ft (95-133 N•m).

13-128