TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 1107 of 1337
TM 9-2320-260-20
Section III. POWER TAKEOFF MAINTENANCE
13-60. POWER TAKEOFF MAINTENANCE INDEX
PARA.
TITLE
PAGE
NO.
NO.
13-61.
Transmission PTO Linkage Maintenance
13-134
13-62.
Transfer PTO Control Linkage Maintenance (M815, M819 W/W)
13-138
13-63.
Transmission PTO Control Linkage Maintenance (M820A2 WO/W)
13-140
13-61. TRANSMISSION PTO LINKAGE MAINTENANCE
THIS TASK COVERS:
a.
Removal
d. Assembly
b. Disassembly
e. Installation
c.
Cleaning and Inspection
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
All w/w
• Parking brake set (TM 9-2320-260-10).
• PTO lever in neutral position (TM 9-2320-260-10).
MATERIALS/PARTS
●
Cab tunnel removed (para. 11-30).
Three cotter pins
Ten locknuts
GENERAL SAFETY INSTRUCTIONS
Lockwasher
●
Keep fire extinguisher nearby when using
Two woodruff keys
drycleaning solvent.
Drycleaning solvent (Appendix C, Item 29)
●
Compressed air source will not exceed 30 psi
Rags (Appendix C, Item 22)
(207 kPa).
REFERENCES (TM)
●
Eyeshields must be worn when cleaning with
compressed air.
TM 9-2320-260-10
TM 9-2320-260-20P
1.
2.
3.
4.
5.
6.
Remove two cotter pins (8), clevis pins (10), and link rod (9) from control lever (6) and lever (11).
Discard cotter pins (8).
Remove two locknuts (2), screws (37), bracket (l), control lever (6), and spacer (7) from
crossmember (36), and shaft (34). Discard locknuts (2).
Remove cotter pin (25), clevis pin (23), and connecting rod (24) from lever (19). Discard cotter
pin (25).
Remove four locknuts (27), screws (14), two brackets (15), and shaft (17) from crossmember (35).
Discard locknuts (27).
Remove screw (30) and lockwasher (31) from power takeoff (33) and power takeoff lever (28).
Discard lockwasher (31).
Remove locknut (29), screw (32), and power takeoff lever (28) from power takeoff (33). Discard
locknut (29).
13-134
Back to Top
