TM-9-2320-260-20

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

APRIL 1995

TM-9-2320-260-20 - Page 1103 of 1337

TM 9-2320-260-20

I

13-58. POWER DIVIDER-TO-HYDRAULIC PUMP PROPELLER SHAFT REPLACEMENT

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

M816

TM 9-2320-260-10

MATERIALS/PARTS

Four locknuts

TM 9-2320-260-20P

EQUIPMENT CONDITION

Parking brake set (TM 9-2320-260-10).

1. Loosen two clamps (6) and slide boots (7) and (10) toward middle of propeller shafts (8) and (9).

2.

Remove four locknuts (12)

and

screws (11) from propeller shafts (8) and (9). Discard locknuts (12).

3. Remove propeller shaft (9) from power divider (1).

4. Remove boot (10) from propeller shaft (9).

5. Remove six screws (13), bearing (5), and propeller shaft (8) from bevel gear (2).

6. Remove boot (7) from propeller shaft (8).

7. Remove screw (4), washer (3), and bearing (5) from propeller shaft (8).

1.

2.

3.

4.

5.

6.

7.

8.

Install bearing (5) on propeller shaft (8) with washer (3) and screw (4).

Install boot (7) on propeller shaft (8).

Install bearing (5) and propeller shaft (8) on bevel gear (2) with six screws (13).

Install boot (10) on propeller shaft (9).

Position propeller shaft (9) on power divider (1).

Install propeller shaft (9) on propeller shaft (8) with four screws (11) and new locknuts (12).

Position front boot (10) on power divider (1) and rear boot (7) on bevel gear (2).

Tighten two clamps (6) on boots (7) and (10).

13-130