TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 1113 of 1337
TM 9-2320-260-20
I
13-63. TRANSMISSION PTO CONTROL LINKAGE MAINTENANCE (M820A2 WO/W)
THIS TASK COVERS:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c.
Inspection
INITIAL SETUP
APPLICABLE MODELS
M820A2 WO/W
REFERENCES (TM)
TM 9-2320-260-10
MATERIALS/PARTS
TM 9-2320-260-20P
Four cotter pins
EQUIPMENT CONDITION
Fourteen locknuts
Parking brake set (TM 9-2320-260-10).
Woodruff key
1. Remove cotter pin (14), clevis pin (13), and clevis (15) from lever (2). Discard cotter pin (14).
2. Bend four tabs (17) upward and remove boot (16) from floor (12),
3. Remove four locknuts (18), screws (19), and two brackets (11) from cab floor (12). Discard
locknuts (18).
4. Remove cotter pin (35), clevis pin (37), and clevis (36) from lever (34). Discard cotter pin (35).
5. Remove cotter pin (25), clevis pin (22), and clevis (23) from power takeoff (24). Discard cotter
pin (25).
6. Remove cotter pin (27), clevis pin (28), and clevis (29) from lever (31). Discard cotter pin (27).
7.
Remove eight locknuts (33), screws (26), and two brackets (21) from crossmember (38). Discard
locknuts (33).
1. Remove locknut (3), screw (1), lever (2), and woodruff key (4) from shaft (5). Discard locknut (3)
and woodruff key (4).
2. Remove two brackets (11) from shaft (5).
3. Remove two grease fittings (20) from brackets (11).
4.
Remove locknut (8), washer (9), spring (10), and lock (6) from lever (7). Discard locknut (8).
5. Remove two spring pins (30) and levers (31) and (34) from shaft (32).
6. Remove shaft (32) from two brackets (21).
1. Inspect shafts (5) and (32) for cracks, breaks, and twists. Replace shafts (5) and (32) if damaged.
2. Inspect three levers (2), (31), and (34) for cracks, breaks, and twists. Replace levers (2), (31), and (34)
if damaged.
13-140
Back to Top
