TM 9-2320-260-20
I
7-21. TORQUE RODS REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPUCABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
MATERIALS/PARTS
TM 9-2320-260-20P
Two cotter pins
EQUIPMENT CONDITION
●
Parking brake set (TM 9-2320-260-10).
Ž Rear axles raised and supported (para. 9-2).
NOTE
There are a total of six torque rods. Two are on the left side of
the vehicle. All torque rods are replaced basically the same. This
procedure covers lower torque rods.
1.
Remove cotter pins (2) and (6) from nuts (3) and (5). Loosen nut (3) and discard cotter pins (2).
2.
Remove nut (5) and torque rod (1) from torque rod mounting bracket (4).
3.
Remove nut (3) and torque rod (1) from cross tube (7).
b. Installation
1.
Install torque rod (1) on cross tube (7) with nut (3). Do not tighten nut (3).
2.
Install torque rod (1) on torque rod mounting bracket (4) with nut (5).
3. Tighten nuts (3) and (5) 350-400 lb-ft (475-542 N•m).
4. Install new cotter pins (2) and (6) on nuts (3) and (5).
7-48