TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 945 of 1337
TM 9-2320-260-20
12-52. OUTRIGGER JACK REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
M816
TM 9-2320-260-10
MATERIALS/PARTS
Locking pin
TM 9-2320-260-20P
EQUIPMENT CONDITION
Lockwasher
• Parking brake set (TM 9-2320-260-10).
Pin
• Outrigger jacks extended (TM 9-2320-260-10).
Locknut
NOTE
Front and rear outrigger jacks are replaced basically the same
way. This procedure covers the rear outrigger jack.
1. Remove lockpin (15) and outrigger jack housing (5) from wrecker body (1).
2. Remove locking pin (6), pin (13), socket (14), and outrigger jack housing (5) from yoke (9). Discard
locking pin (6).
3. Remove pin (8), collar (7), yoke (9), and washer (10) from adjusting screw (11). Discard pin (8).
4. Remove adjusting screw (11) from base (12).
5. Remove screw (2), lockwasher (3), and plate (4) from wrecker body (1). Discard lockwasher (3).
NOTE
Perform step 6 for front outrigger jacks.
6. Remove locknut (19), screw (17), washer (16), and plate (18) from wrecker body (1). Discard
locknut (19).
b. Installation
NOTE
Perform step 1 for front outrigger jacks.
1. Install plate (18) on wrecker body (1) with washer (16), screw (17), and locknut (19).
2. Install plate (4) on wrecker body (1) with new lockwasher (3) and screw (2).
3. Install adjusting screw (11) in base (12).
4. Install washer (10) and yoke (9) on adjusting screw (11) with collar (7) and new pin (8).
5. Position socket (14) and outrigger jack housing (5) on yoke (9), and install with pin (13) and new
locking pin (6).
6. Position outrigger jack housing (5) on wrecker body (1) and secure with lockpin (15).
12-108
Back to Top
