TM-9-2320-260-34-1
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 1 OF 2
JULY 1994
TM-9-2320-260-34-1 - Page 89 of 657
TM 9-2320-260-34-1
3-14. ROCKER LEVER HOUSING COVERS REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
MATERIALS/PARTS (Contd)
All
Five screw-assembled lockwashers (late models)
TOOLS
(Appendix D, Item 395)
General mechanic’s tool kit
REFERENCES (TM)
(Appendix B, Item 1)
TM 9-2320-260-10
Torque wrench, 3/8-in. dr.
TM 9-2320-260-34P-1
(Appendix B, Item 4)
EQUIPMENT CONDITIONS
MATERIALS/PARTS
Parking brake set (TM 9-2320-260-10).
Gasket (Appendix D. Item 103)
Five lockwashers (early models)
(Appendix D, Item 225)
NOTE
All rocker lever housing covers are replaced the same way. This
procedure covers the rear rocker lever housing.
1. Loosen two clamps (2) and remove draft tube hose (1) from crankcase breather (3) and elbow (10).
2. Remove five screws (4), lockwashers (5), washers (6), rocker lever housing cover (7), and gasket (8)
from rocker lever housing (9). Discard lockwashers (5) and gasket (8).
1. Install new gasket (8) and rocker lever housing cover (7) on rocker lever housing (9) with five
washers (6), new lockwashers (5), and screws (4). Tighten screws (4) 10-15 lb-ft (14-20 N•m).
2. Install draft tube hose (1) on crankcase breather (3) and elbow (10). Tighten two clamps (2).
3-37
Back to Top
