TM-9-2320-260-34-2

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 2 OF 2

JULY 1994

TM-9-2320-260-34-2 - Page 751 of 863

TM 9-2320-260-34-2

17-19. PERSONNEL HEATER FUEL LINE AND BLOWER HOUSING REPLACEMENT

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

All

TM 9-2320-260-34P-2

TEST EQUIPMENT

EQUIPMENT CONDITION

Multimeter (Appendix B, Item 115)

Personnel heater igniter removed (para. 17-18).

TOOLS

General mechanic’s tool kit

(Appendix B, Item 1)

Tool kit, electrical (Appendix B, Item 106)

NOTE

Fuel line and blower housing are replaced the same for early and

late model heaters. This procedure is for early model heaters.

a. Removal

1. Loosen nut (3) and remove fuel line (4) from fuel control valve (1).

2. Loosen nut (5) and remove fuel line (4) from burner fuel inlet (6).

3. Remove blower housing (2) from heat exchanger (7) and heater housing (8).

b. Installation

1. Place blower housing (2) in heater housing (8).

2. Install fuel line (4) on burner fuel inlet (6) through blower housing (2). Do not fully tighten nut (5).

3. Install fuel line (4) on fuel control valve (l). Finger tighten nut (3).

17-50